Eclipse PE300BU, Руководство оператора

Страница: 20 / 44

20
Rear Casters
Each of the two rear casters has two grease fittings.
Lubricate each caster with a grease gun every 100
hours of machine operation
Belt Maintenance (30” Models)
1. Push machine to level surface.
2. Turn machine off and disconnect the battery pack.
3. Lift up on the front of the deck, placing the deck in
the pad change position.
4. Remove the pad retainer and pads from the pad
holders.
5. Remove the pad holders from each of the drive
pulleys, by removing the (4) bolts in the center of the
pad holder.
6. Locate and remove the (4) bolts that fasten the pulley
cover to the deck.
7. Rotate the deck belt. If there are excessive cracks in
the belt ribs and chunks that have broken off the ribs,
the belt needs to be replaced.
Belt Replacement
Part No: MP449100
1. Place a 9/16” wrench on the bolt of the tensioner
idler pulley and rotate the tensioner downward.
2. With the tension removed, remove the belt from the
tensioner pulley.
3. Slowly allow the tensioner to rotate to a natural
position.
4. Remove the belt from the deck.
5. With belt removed, inspect all of the fasteners for
proper tightness. Also check the bearings for wear
and the condition of each pulley.
6. Install the new belt using the belt diagram.
7. Use a 9/16” wrench to rotate the tensioner down so
the new belt can be installed.
8. Slowly allow the tensioner to tighten against the belt.
9. Turn the belt through several revolutions to make
sure the belt tracks properly.
10. Reinstall the pulley cover.
11. Reinstall the pad holders on to the drive pulleys.
12. Turn the pad holders to verify that there is no
interference.
13. Install pads onto the pad holders.
14. Slowly lower the deck back to the operating position.