Eclipse PE300BU, Руководство оператора

Страница: 22 / 44

22
Machine Troubleshooting
Problem Possible Cause Remedy
Machine will not turn on
Breaker Tripped Push breaker button to reset
Incorrect battery connection
Check batteries are wired together correctly via the battery connection diagram,
check the Anderson connectors are plugged together
On-board battery charger plugged in Unplug the charging cord from the machine
Key switch failure Check key switch is functioning and wiring to the key switch is correct
Failed Fuse Check the fuse in the in line fuse holder.
Burnish motor will not
start
Deck tilted into pad change position Lower the deck to the burnish position
Speed control knob turned all the way counter-
clockwise (off)
Turn speed control knob clockwise to increase speed
Burnish switch off Turn on burnish switch
Handle levers not engaged Engage handle levers
70A breaker tripped
Push 70A breaker to reset. DO NOT use round pads on the PE300BU30X. Using
round pads will shorten the run time and trip the breaker. The use of round pads on
this machine will damage the burnish motor and void the warranty.
Battery lockout Batteries need to be charged
Red LED Flashing on
Dash
Check alarm code reference sheet Troubleshoot accordingly
Machine exhibits poor
burnishing performance
Pad dirty Remove debris or string/twine from pads; clean pad; replace pad
Incorrect pad Use more aggressive burnishing pad
Pad worn down Replace pad
Machine exhibits very
aggressive burnish
performance
Gas Spring faulty
Check ampere draw of burnish motor (should not be above 50 amps); replace gas
spring
Incorrect pad Use less aggressive burnishing pad
Dust collection not
working properly
Dust collection bad, is not collecting dust
Empty dust bag
Check the dust tube to see if there is an obstruction
Skirt is not sealing to the floor
Skirt is bent or damaged. Replace if necessary.
Adjust the skirt to fit tightly against the seal, but still able to move freely
Check wear edge on bottom of the skirt and replace if necessary
(30”) Smell of burnt
rubber
Belt out of adjustment Check the automatic tensioner