Chapter 2
Page 40
Receiver Description and Installation
3. On Remote Control 1, press
MENU-6-1-1
to display the
Point Dish/Signal
screen on the nearby TV.
4. Select
Check Switch
. When an attention screen displays, select
Retest
.
5. The receiver begins performing the
Check Switch
tests. When it is
finished, the
Installation Summary
screen displays.
6. Make sure that the information on the
Installation Summary
screen
identifies your system correctly and shows all transponders for all satellites
in your system. Your screen may look different from the example above
depending on the dish antenna system you are using.
7. Select
OK
to go to the
Point Dish/Signal
screen.
8. Select
Cancel
to exit the
Point Dish
menu. An
Attention
screen will open
asking the mounting and positioning of your dish is complete with a
Locked
indication in the
Point Dish
screen. If the answer is yes, select
Yes
.
9. After you select
Yes
, the receiver will begin taking a software upgrade. You
will see a
Warning
that
Vital program information will now be
downloaded into your receiver
. You will also see a status bar showing the
progress of this upgrade.
10. Once the software upgrade is complete, you will see a message that your
receiver’s memory is being upgraded.
11. Do not disturb the receiver while the receiver’s memory is being upgraded.
Note
: If you are installing other DISH Pro or DISH Pro Plus receivers, be
sure to run
Check Switch
on all of them, and allow them to take the
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV. Your
dish antenna installation is now complete.
Содержание DISH Pro
Страница 54: ...Chapter 2 Page 48 Receiver Description and Installation Notes ...
Страница 140: ...Chapter 4 Page 134 Dish Antenna Installation Notes ...
Страница 158: ...Page 152 Chapter 5 Reference Notes ...
Страница 159: ......