7
Connection
Colour
Specification
LOAD x 2
Red
14AWG, 600V
Neutral
White
18AWG
Line 120VAC
Black
18AWG
Line 277VAC*
Brown
18AWG
Line 347VAC*
Yellow
18AWG
Dimming 0-10V
Violet
22AWG
Dimming GND
Grey
22AWG
24V+
Red
22AWG
24V GND
Black
22AWG
Sensor Input
Yellow
22AWG
*not used in all models
Diagnostic LED’s and buttons
Learn Button -
The LEARN button is used to link a switch or switch to the
ERDRC controller.
1. Press the LEARN button for a half second. In link mode the LEARN LED will
stay ON and the POWER LED will toggle every 2 seconds.
2. Using the switch that you will link to the controller, press the wall switch
three times. If linking a sensor, press the sensors TEACH button. The
POWER LED will remain lit for 4 seconds while it links the new device. It
will resume toggling allowing you to link another device up to a total of 20
devices. Linking a switch or sensor that is already linked to a controller, will
remove or un-link it from the controller.
3. To exit link mode, press the LEARN button on the ERDRC controller again
for a half second. Link mode will time out after no activity in 30 seconds.
Clear Button -
The CLEAR button erases all devices linked to the ERDRC controller
and resets the controller to factory default settings. Press the CLEAR button i for
5 seconds. The LEARN LED will flash ON for 1 second and then OFF to complete
the step. The table below describes the LED activity and associated mode of the
controller.
Description
Power
Learn
LINK mode
Toggle 2 sec.
ON
Storing ID
ON 4 sec.
ON
Clearing ID
OFF 4 sec.
ON
CLEAR mode
N/A
ON 1 Sec.
Normal operation:
see below
OFF
