5
• Avoid large obstructions. Place receivers in alternate locations to avoid the
radio shadow or use repeaters to go around the obstacle.
• Do not locate receivers close to other high frequency transmitters. Leave
at least 2’ between the receiver and any other source of interference
including lighting ballasts, computers, video equipment, Wi-Fi/LAN
routers, GSM modems and monitors. Transmitters are not affected by
these sources of interference.
• Avoid transmitting down a length of wall to reduce signal reflection.
• Avoid large obstructions. Place receivers in alternate locations to avoid the
radio shadow or use repeaters to go around the obstacle.
• Do not locate receivers close to other high frequency transmitters. Leave
at least 2’ between the receiver and any other source of interference
including lighting ballasts, computers, video equipment, Wi-Fi/LAN
routers, GSM modems and monitors. Transmitters are not affected by
these sources of interference.
Preparing to Install the ERDRC
The ERDRC is mounted to an electrical junction box or panel with a ½” threaded
nipple. The ERDRC must be mounted on the outside of a junction box either
directly at the electrical load or before the load in the circuit. The ERDRC is for
indoor use only.
You will require hand tools to gain access to the junction box and remove any
cover plates or other hardware. A pin or pen may be needed for pressing the
controller buttons when assigning the wireless switches.
