10
below and the OFF set point 7.5% above this optimum room light level.
• With the light on, tap the light sensors teach button 3 times to set the
light level set points using the current existing light level recorded at the
sensor. The light will blink once to acknowledge the change.
• Move away from the sensor to avoid affecting the light level. The next
transmitted light value from the sensor will be used to set either the
maximum dimming set point or the light-on-set point.
• The light will blink once again to complete the process.
2.
Setting the set point to an absolute value -
You may also set the lighting
set point to an absolute value useful in open-loop sensor applications. If
the dimming output is enabled, the absolute value selected becomes the
maximum dimming set point. If the output is disabled, the absolute value
selected becomes the Light-ON-Set point.
• With the light on, tap the light sensors teach button 4 times to set the set
point to 20%.
• Tap the button additional presses incrementing the set point value by
20%. Five (5) taps would equal 40%, seven (7) taps would be 80%.
• The light will blink once at three taps and then begin blinking according
to the level set to confirm the change after 3 seconds.
Absolute Set points with Dimming Output Enabled
Taps
Max.Dim SP
Min.Dim SP
Blinks
3 taps
Sensor
20%
1 blink
4 taps
20%
40%
2 blink
5 taps
40%
60%
3 blink
6 taps
60%
80%
4 blink
7 taps
80%
100%
5 blink
Absolute Set points with Dimming Output Disabled
Taps
Light-OFF SP
Light-ON SP
Blinks
3 taps
7.5%
Sensor-7.5%
1 blink
4 taps
23%
20%
2 blink
5 taps
46%
40%
3 blink
6 taps
69%
60%
4 blink
7 taps
92%
80%
5 blink
