13
Clear switches or sensors (restore factory defaults)
• Enter Smart Click configuration mode and click the switch ON or OFF until
the light is blinking twice. Press ON for three seconds. Click the switch ON 5
times to clear the switch,
• click ON 5 times again to clear ALL switches and sensors and reset the
ERDRC to factory defaults.
• Press OFF for 5 seconds to complete clearing.
Repeater Function -
repeats any telegram within range. EnOcean telegrams can
only be repeated once.
The repeater function can be enabled/disabled by accessing the controller
buttons. Press the Clear button and hold then quickly press the Learn button
once to disable, twice to enable. The learn led will blink once when disabling,
twice when enabling the repeater function. Release the Clear button. If there is
no access to the controllers buttons, follow the Smart Click steps below.
• Enter Smart Click configuration mode and click the switch ON or OFF until
the light is blinking three times.
• Press ON for 3 seconds. If the repeater function is enabled the light will
turn ON, if disabled the light will be OFF.
• Click ON to activate this function, OFF to deactivate.
• To continue with configuration, press ON for 3 seconds, the light will
resume blinking three times. To exit Smart Click press OFF for 5 seconds.
Status Telegram -
the ERDRC can broadcast a status telegram per EEP: A5-11-01.
The telegram will broadcast every 100 seconds. Refer to the table on page 9 for
a detailed explanation of the telegram.
If the ERDRC has a wired occupancy sensor connected to the low voltage input,
this sensor status can be shared with other controllers. The ERDRC must be first
linked with the receiving controllers. Enabling the status telegram activates
the shared occupancy feature and also sends the learn command to the other
controllers for linking.
The status telegram can be enabled/disabled by accessing the controller
buttons. Press the Learn button and hold, press the Clear button once to disable,
twice to enable (this sends the learn telegram). Release the Learn button. The
learn led will blink once when disabling, twice when enabling this telegram.
If there is no access to the controllers buttons, follow these Smart Click steps.
Enter Smart Click configuration mode and click the switch ON or OFF until the
light is blinking four times
Press ON for 3 seconds. If the status telegram function is enabled the light will
turn ON, if disabled the light will be OFF
Click ON to activate this function, OFF to deactivate
To continue with configuration, press ON for 3 seconds, the light will resume
blinking four times. To exit Smart Click press OFF for 5 seconds
