English
English
8
•
Never use your fingers, kitchen utensils or other objects to push food into the grater! Use only the tamper
supplied with the accessories. Use reasonable force. Excessive pressure could damage the appliance.
•
If food residues get stuck in the grater, switch off the appliance immediately and disconnect it from the
mains. Only then remove and clean the grater.
•
Before replacing accessories that move during use, switch off the appliance and disconnect it from the
power supply.
•
Use damp cloth for cleaning and maintenance. Do not use chemical agents.
ASSEMBLING THE STAND MIXER
•
Before first use, clean all accessories with lukewarm water with detergent, rinse and dry thoroughly. Do not
immerse the body of the appliance in water. Wipe it with a damp cloth. Do not use any abrasive or other
aggressive cleaning agents.
•
Place the appliance on a flat, clean and dry table so that it has enough space around it.
•
Press the multifunction head release lever (2) while lifting the multifunction head (10) with your other
hand until you hear a click. The head is now locked in the top position (see figure 2).
•
Place a stainless steel bowl with ingredients on the base of the appliance and secure it in place by turning
it clockwise.
•
Make sure that the total amount of ingredients does not exceed 1.5 kg.
•
Insert the bowl cover (8) on the multifunction head first and then the required accessories (5, 6, 7) on
the head shaft (1). Push the accessory up and then turn it a quarter turn counterclockwise to the locking
position (Figures 4 and 5).
•
Press the multifunction head release lever (2) while lowering the multifunction head (10) to a horizontal
position. The head must "click" into the base.
•
Insert the plug into the socket and the control panel display will light up.
•
Select the speed and time on the control panel. After the set time has elapsed, the stand mixer
automatically shuts off.
Note:
For more information on operation, see the section "DESCRIPTION OF THE
CONTROL PANEL AND DISPLAY".
•
Press the release lever of the multifunction head (2) and lift the head (10) (see figure 2), turn the bowl
counterclockwise, remove and remove the finished dough.
Note:
When the head is tilted, the control panel display turns off. Lights up again when the head is tilted back.
Note:
It is not possible to use two accessories at the same time (e.g. whisk with a grinder, etc.).
WARNING:
Do not leave the appliance running continuously for more than 15 minutes. Allow it to cool for at
least 30 minutes before starting again.
