ECG ESP 20501 Iron, Инструкция по эксплуатации

Страница: 16 / 192

English English
16
3. Insert the lever with filter WITHOUT COFFEE into the steam head and secure. Leave the lever in the
appliance throughout the descaling process.
4. Press the two cups button ( ). Allow the solution to flow freely through the metal cup into a pre-
prepared container. Then switch the machine to "hot water" mode and pump approx. 100 ml of solution
through a nozzle into a prepared container. Allow the solution act for about 5 minutes. Repeat the step 3x.
5. Then fill the tank with clean water to the MAX line and repeat step 4 (alternating rinsing through the cup
and nozzle) at least twice. In this case, it is not necessary to observe the 5-minute interval between cycles.
TROUBLESHOOTING
Problem Cause Correction
Water leak from the bottom of
the machine.
There is too much water in the drip
tray.
Clean the drip tray.
The machine does not work. Please, contact an authorized service
center.
Water leak from the side of
the filter.
There are remains of coffee grounds
on the edge of the filter.
Remove the coffee remains.
The espresso tastes sour
(vinegary).
The descaling agent has not been
entirely removed after cleaning of
the mineral deposits.
Repeat the procedure described in
the section "When using for the first
time" several times.
Ground coffee was stored for a
long time in a warm and humid
environment. Ground coffee has
spoiled.
Use fresh ground coffee and store
unused coffee in a dry and cool
place. After opening the ground
coffee package, close it tightly and
store it in the refrigerator to keep the
coffee fresh.
The coffee machine does not
work.
The power cable is not plugged
correctly.
Plug in the power cable correctly.
If the appliance still does not work,
please contact an authorized service
center.
Steam frothing is failing. The operation indicator did not
light up.
The steam is only ready for foaming
when the operation indicator (white)
lights up.
The kettle used is too large or its
shape does not fit.
Use a tall, narrow kettle.
You used skimmed milk. Use whole or half-skimmed milk.
Fast flashing one cup indicator
and two cup indicator
The water in the boiler is too hot.
The selector lever was not turned
back to neutral (OFF) after the unit
cooled down.
Allow approx. 215 ml of water to
flow through the nozzle, see chapter
Frothing milk / making cappuccino.
Turn the selector lever to neutral
position (OFF).
Fast flashing steam indicator The selector lever was not turned
back to neutral position (OFF).
Turn the selector lever back to the
neutral position (OFF).
All indicators flash quickly 5
times in succession
The coffee machine needs to be
descaled
Carry out descaling according to the
instructions in the chapter "Cleaning
of mineral deposits".
Immediately after switching
on the machine, all icons
flash quickly and the machine
beeps.
The selector lever was not turned
back to the neutral position (OFF)
before the machine was turned off.
Turn the selector lever to neutral
position (OFF).