Ecco ED5050 Series, Инструкция по установке и эксплуатации

Страница: 3 / 16

Page 3 of 4
P/N 920-5050-00 (Rev E) 2018-06-29
Pattern MODE PATTERNS SYNC
SAE J595 (CLASS 1) CA T13 (CLASS B) ECE R65 (CLASS 1)
RED/AMB/BLU/WHT RED/AMB/BLU AMB/BLU
1
1 Single Flash 75FPM sim. Phase1 YES
 
2 Single Flash 75FPM sim. Phase2 YES
 
2
3 Single Flash 120FPM sim. Phase1 YES
 
4 Single Flash 120FPM sim. Phase2 YES
 
3
5 Double Flash 75FPM sim. Phase1 YES
 
6 Double Flash 75FPM sim. Phase2 YES
 
4
7 Double Flash 120FPM sim. Phase1 YES
 
8 Double Flash 120FPM sim. Phase2 YES
 
5
9 - Default Quad Flash 75FPM sim. Phase1 YES
 
10 Quad Flash 75FPM sim. Phase2 YES
 
6
11 Quad Flash 150FPM sim. Phase1 YES
 
12 Quad Flash 150FPM sim. Phase2 YES
 
7
13 Triple Flash 75FPM sim. Phase1 YES
 
14 Triple Flash 75FPM sim. Phase2 YES
 
8
15 Quint Flash 150FPM sim. Phase1 YES
 
16 Quint Flash 150FPM sim. Phase2 YES
 
9 17 Steady Burn NO
10
18 Modulation NO
Flash Patterns
Note: ‘sim’ means LED light heads will flash simultaneously and ‘ALT’ means that LED light heads set to Phase 1 patterns will flash alternately to
LED light heads set to Phase 2 of the same pattern.
Trouble Shooting:
Your ED5050 has been factory tested and approved. If the functions of the device fail, please check the following:
• After connecting with the power supply, be sure that the cables are connected correctly. Make sure there is not a short circuit.
• Plug in the device; ensure the LED power switch is on.