678/03.05.23/V2
P a g e
| 19
of 28
Ecco Stove | Foster House | 2 Redditch Road | Studley | B80 7AX | United Kingdom
T
| +44 (0) 1527 857 814
E
W
| www.eccostove.com
For all patents
–
See Addendum
The back section has a tapered base which fits into the taper on the
bottom section. Stand the back section carefully in place gently
wedging off the rear wall of the stoves chosen location until held
in position by the rear top section:
E. DOOR SECTION
Door section should now be lowered over the sides until it sits firmly and
squarely onto the bottom section. Seals must be fitted (10mm round rope)
into the groove down left and right hand sides and across the grate section
to enable the door frame to seal onto.
NOTE: The tertiary air intake hole should be at the
bottom and not the top of the back section. This hole is to be left
permanently open. Ensure the rear section locates down inside the
rear trim and doesn’t ride high on the trims flange.
F.
POSITION TRIM (no trim with trimless model)
The ‘T’ shaped joint seal / trim onto the top horizontal face ready
for the next section to hold in place. This seal butts up to the door
frame left and right.
Steel baffle has air tubes linking it to the vermiculite
pre-drilled back boards to introduce hot air to mix with the air
wash/secondary burn process. The rear section of the steel baffle
must sit into the stoves back panel and house the vermiculite
back boards in front of its half box section.
