EBS EPX400-5C, Инструкция по установке и программированию

Страница: 67 / 73

EPX400-xC – Manual Page 67 / 73
SERVER=server address
SERVER=
(empty string, without the
parameter) If the role of the GPRS channel is sets as "Unused", this
command sets the address of the server and the role GPRS
channel as "Backup."
If the role of the GPRS channel is DIFFERENT than "Unused"
(it’s mean turned on), this command sets only the address
of the server.
Clears the server address.
NOTE: The Transmitter will not attempt communication with
the server via GPRS.
PORT=port Server port number.
DNS1=dns1 Specifies primary DNS server address (only needed when
domain name address is used as
SERVER address)
DNS2=dns2 Specifies secondary DNS server address (only needed when
domain name address is used as
SERVER address)
SMS=phone number
SMS=
(empty string, without the
parameter) If the role of the SMS channel is set as "Unused", this
command sets the phone number of the server and the role
of SMS channel as "Emergency". When there is GPRS failure,
SMS with events will be sent to this number.
Clears the phone number.
NOTE: The Transmitter will not go into SMS mode.
SMSPERIOD=time Defines in minutes time between SMS test messages
sending to the server.
RLIMIT Removes automatic temporary locks on all inputs
RLIMIT=inputs_mask Removes selected automatic temporary locks. Parameter is
decimal number made from 10-bit word: A10 … A2, A1,
where A1 always equals 0, A2 means INPUT 1, A3 means
INPUT 2, and A10 means INPUT9.
EXAMPLE:
RLIMIT=6 removes locks on inputs:IN1, IN2
RLIMIT=2 remove lock on input IN1
DT=YY/MM/DD,hh:mm:ss Sets date and time in the transmitter; must be putted in a
specific format (see the table on the left)
FLUSH=x Flushes events buffer, where x is:
 2 – system events history
ETHSERVER=server_addres
s:port
ETHSERVER=
(tzw. empty string)
Server address and port which the transmitter EPX will
connect. If the role of the channel ETHERNET was set as
"Unused" is now set to "Main".
Example:
ETHSERVER = 89.123.115.8: 9000
The command returns:
EOK - entered correctly value;
EFORMAT - incorrect format of the command;
EINVALID - if incomplete (e.g. the lack of port), or entering
other characters after “:” than numbers.
Deleting the set server address.