EBS EPX400-5C, Инструкция по установке и программированию

Страница: 42 / 73

EPX400-xC – Manual Page 42 / 73
Note: The phone number must be entered without country code (e.g. without
prefix 0048 and +48).
 Dependent on state transitions from non-active to active of one of the inputs.
Outputs can be also activated by internal watchdog (see 8.8. Link control).
8.3.3.3. Additional conditions
If option “Dependent on state transitions from non-active to active of one of the
inputs” is chosen, we might configure additional conditions for output activations:
o
Never: input disturbance does not cause operation of the output,
o
No network: input disturbance causes actuation of the output if sending of
information to server is impossible.
o
Always: every input disturbance causes actuation of the output.
o
Available network: input disturbance causes actuation of the output if
sending of information to server is possible.
Note : The outputs may be controlled by SMS commands.
The outputs can also be activated by the watchdog that can be configured in tab
"8.8. Link control”.
8.3.4. Advanced outputs control
The user is able to determine an alternative course of action to go over basic outputs
configuration function described in 8.3.3. Outputs.
In the “Advanced outputs control” you may define separately the behavior of each of
the outputs, depending on events taking place. “Advanced outputs control” differs
from the existing basic “Outputs configuration” by:
o
it is possible not only to turn on but also to turn off the output
o
output can be activated temporarily for specified amount of time
o
there is a complete list of events for which you can define the behavior of the
output.
Note: Do not use at the same time the basic configuration of outputs (8.3.3
Outputs) and the “Advanced outputs control”!
In particular, the basic configuration of existing options: “No GSM signal
(immediately after detection)” and “Dependent on state transitions from non-active
to active of one of the inputs” should not be used with their replacements “[Off]
GSM” and “[On] Input x”. The use the basic configuration of outputs and “Advanced
outputs control” at the same time, may cause unexpected behavior of the
transmitter.