programming parameters Pr16 and Pr17 but are only active if Pr14 is set to 1. Display toggles
between current position display and “LL” or “UL”. The position is shown for 2 seconds and
the “LL” or “UL” is shown for 2 seconds. This continues as long as a limit has been exceeded.
Limit monitoring is always active, even in programming mode.
Numerous Programming parameters, including Offset Addition and Limit mode indicate a
“factory default set in inches”. The equivalent offset/limit value in mm or cm is applied if you
switch the MODE of display to mm or cm. i.e. these parameter values take on the unit
measurement MODE (mm, cm or inches) active when programming is entered.
Section (1j) Scaling
All general purpose digital displays have the ability to “scale” the actual measurement. This
function is useful when the actual measurement must be multiplied or divided before being
displayed. Care should be taken when using this function since invoking it will cause the unit
to display a reading different than the actual measured or traversed value. This function is set
using Programming Parameter Pr7. The factory default is set to 1.000 – No Scaling
Section (1k) Changing Batteries
A low battery indicator will appear in the lower left corner of the LCD display when new
batteries are needed.
Surface Mount Displays
: remove the screws in the upper right and lower left corners. Pull
cover off. Remove the old batteries. Reinstall new AA Alkaline batteries, noting the proper
orientation. Replace the cover and tighten the screws.
CAUTION: DO NOT BEND BATTERY CLIPS!
THESE CLIPS ARE DESIGNED TO BE LOOSE WHEN THE CASE IS OPEN AND WILL
COMPRESS AND SECURE THE BATTERIES IN PLACE WHEN THE CASES ARE
SCREWED TOGETHER.
REV A 12-2-05 27
