of the wooden base (
Extreme care should be used as this machine is top heavy so use
caution and care
)
3.
Roll the machine in the center to the front of your shop, measure the width of your
door to make sure you can get the machine thru. If the door you must use is narrow
simply set the machine down and then slide the dolly under the stand from the side of
the machine (
Again use caution and, make sure you have plenty of help as the machine
is top heavy
). Now roll the machine in to your location as close as you can and set
down.
4.
Remove the dolly from the machine and slide the machine into the location that you
want. Again when sliding make sure that you do not tip the machine and use care as
the machine is heavy enough to damage tile or carpet. You may find it best to place
card board under the stand to help slide in to position. Once in place tip the machine
slightly and pull the cardboard from under the machine. If the machine rocks due to the
floor being unlevel you may need to shim the sides of the stand to firm the machine up
and keep it from rocking during operation.
Section (3) Preliminary Set-Up
1.
Using the silver wrench that is included loosen the two large nuts on the right hand side
of the machine. ( Right side as you are facing the machine) Pictured Below.
REV A 12-2-05 4
