(60)
EBARA
Corporation
60 deg or less
(8) Use the eyebolts provided on the pump for slinging the pump to load and unload.
Fasten eyebolts completely and push in until flush with the seating surface. For sling,
use a wire with a length so that the slinging angle (that is, the angled subtended by
the two wires) is within 60 degrees.
DANGER
Do not enter the zone underneath the suspended pump.
WARNING
For lifting the pump, use only qualified operator personnel.
Be sure that the wire rope and crane used for lifting the pump are in proper order
and match the weight of the pump.
To prevent unequal weight distribution, suspend the pump by ensuring that the
slinging angle remains symmetrically centered.
CAUTION
In case of sling and transportation, be sure not to remain leaning more than 10 deg
against a horizontal for 5 minutes. If not, oil leakage will occur.
Fig. 9.1 Slinging the Pump
(9) When options such as an interface box are attached to the pump, be careful
to avoid damage due to contact by the wire rope.
(10) For transportation, secure the pump by lowering the adjustment feet. Place a
protective cloth around the pump to avoid shock and position protective
members between the outer cover and the wires in order to distribute the
load of the fastening wires.
To avoid dangers potentially encountered during pump overhauls, follow
instructions shown in section 8.7, Appendix 4 or 5 to send your pump to an
Ebara-designated factory for overhaul or repair.
LCD Contlorer