9
On power up:
Hold Input Select and High Pass Filter buttons --- reset all settings to factory default
(all user settings will be overwritten)
Hold Mode buttons --- put into boot mode
(only used for troubleshooting)
3 . 2
I n i t i a l C o n t r o l S e t t i n g s
Use these nominal settings for the rear panel switches. These are multi-state “soft” switches which
control software functions. Repeatedly pressing each switch cycles through its multiple states.
3.2.1
FULL-RANGE WITH NO SUBWOOFER
CONTROL
SETTING
LED INDICATION
High Pass Filter
55Hz
Both LED’s off
Mode
Normal
Both LED’s off
Input Select
Normal
Center LED on (Norm/Analog)
3.2.2
FULL-RANGE WITH SUBWOOFER
CONTROL
SETTING
LED INDICATION
High Pass Filter
80Hz
Top LED on
Mode
Normal
Both LED’s off
Input Select
Normal
Center LED on (Norm/Analog)
WARNING:
Before connecting an JF
NT
/KF
NT
loudspeaker to the AC mains supply,
completely turn down the input signal to the loudspeaker using the signal source's output level
(master volume control or other output level control). If not, there could be excessive and
possibly damaging sound levels from the loudspeaker when energized.
3 . 3
A u d i o C o n n e c t i o n
Connect the output from your line-level signal source to the XLR-3F INPUT connector on the rear
panel. This is an electronically balanced input.
3 . 4
A C M a i n s C o n n e c t i o n
Connect the supplied AC mains cord to the Neutrik PowerCon socket on the rear of the
loudspeaker. Connect the other end to an AC mains supply receptacle, nominal 115 V 60 Hz or 230
V 50 Hz as labeled on the loudspeaker. If necessary, have a qualified electrician change the cable
plug as required for compatibility with the local ac mains receptacle.
CAUTION:
There is no power switch on the loudspeaker. When connected to the AC mains
the loudspeaker will be fully operational, with the output level controlled by the signal source
feeding the loudspeaker.
3 . 5
A d j u s t i n g t h e O u t p u t L e v e l
With a source program playing, gradually turn up the level of your signal source until the desired
volume is reached but below the point where the CLIP and/or LIMITER ACTIVE lights illuminate.
CAUTION:
If there is no sound, turn down the signal source's output level before investigating the
problem. Do this to avoid excessive and possibly damaging sound levels from the loudspeaker.
