VORSICHT:
Das mitgelieferte Netzkabel besitzt möglicherweise einen etzstecker, der nicht in
Ihre Steckdose passt. In diesem Fall können Sie sich von einem zugelassenen Elektrobetrieb
einen passenden Netzstecker unter Berücksichtigung der jeweils gültigen Vorschriften
montieren lassen.
WARNUNG:
Stellen Sie sicher, dass er Schutzleiter der Netzsteckdose ein gute Verbindung
zur Erde hat. Nichtbeachtung dieses Hinweises kann zu Schäden am Equipment, zu
Verletzungen oder zum Tod führen.
6.3.5
AC LOOP CONNECTOR (KF200
NT
ONLY)
The Neutrik PowerCon AC mains and AC loop connectors are wired in
parallel to provide an AC mains inlet and outlet on each KF200
NT
. The blue
AC mains inlet mates with a Neutrik PowerCon NACFC3A (supplied). The
white AC mains outlet mates with a Neutrik PowerCon NACFC3B (also
supplied). Therefore, to loop the AC mains from enclosure to enclosure,
connect the AC mains jumper cable as shown.
Up to four KF200
NT
s can be looped in this fashion. Use the AC loop
connector to daisy-chain AC mains power from one enclosure to another.
The maximum, continuous load must not exceed 12A for the 115V version
and 6A for the 230V version.
NOTE: The circuit breaker only protects the AC loop outlet, not the AC
mains connector. If the continuous load connected to the AC loop outlet
exceeds the rated load, the circuit breaker will trip. For this situation,
reduce the connected load and then manually reset the circuit breaker.
6.3.6
POWER ON / OFF
CAUTION:
There is no power switch on the loudspeaker. When connected to the AC mains,
the loudspeaker will be energized and fully operational with the output level controlled by the
signal source feeding the loudspeaker.
Connect the supplied AC mains cord to the PowerCon jack on the rear of the loudspeaker. The
PowerCon system uses a locking connector. To lock, twist 1/4 turn clockwise after fully inserting
it into the jack. Then, connect the other end of the cable to the AC mains supply receptacle. This
will energize the loudspeaker.
Power On Sequence:
When energized, the loudspeaker's electronics will initialize. The initialization sequence will last
between 1.5 and 2 seconds. During this time the amplifier outputs are muted. The indications for
normal initialization are:
1. All LEDs will illuminate steadily, starting from right to left: Input Select, U-NET,
Amplifier Status, Input Level, High Pass Filter, and Mode.
The LEDs will then illuminate according to the current status of the functions they indicate.
2. The Clip, Limiter Active, and Signal Present LEDs will flash together.
3. The LEDs will then flash twice in the following sequence:
Clip, Limiter Active, and Signal Present.
4. The Clip, Limiter Active, and Signal Present LEDs will go off;
the Amplifier Status LEDs will come on, illuminated green.
If it is desired to completely power off (de-energize) the loudspeaker, a conveniently located AC
mains disconnect must be supplied or the power cable must be unplugged from the AC mains supply.
N
e
u
trik
N
AC3FCA
To AC Mains In
N
e
u
trik
N
AC3FCB
From AC Mains O
u
t
Recommended cable length for connecting
vertically adjacent enclos
u
res =
300 mm to 450 mm / 12 in to 1
8
in
17
