Eaton UltraShift PLUS Series, Руководство по обслуживанию

Страница: 171 / 263

2018.12.12
© 2017 Eaton. All rights reserved
160
TRSM0940 Service Procedures | Oil Pump and Lube Tube Installation
2 8 . Install the rear Main Shaft Bearing onto the Main Shaft.
Using a plastic hammer or hammer and brass drift,
drive the bearing into the bore of the intermediate wall.
29. Install the rear Main Shaft Bearing retaining plate and
cap screws; torque the six cap screws to 35–45 lb-ft.
Note: Ensure the Retainer Ring is installed in the
proper direction. The inner grove should fit over the
bearing.
30. Install the Auxiliary Drive Gear onto the Transmission
Main Case Main Shaft.
31. Install the Auxiliary Drive Gear snap ring.
Note: If the snap ring will not fit into the groove verify
that the Main Shaft is pulled to the rear of the Trans-
mission.
32. Install both upper and lower Auxiliary Counter Shaft
Front Bearing Races into the Transmission Main Case
intermediate wall if removed.