Transmission appearance may differ, procedure is the same.
12
Output Shaft Assembly
How to Disassemble the Output Shaft Assembly
Special Instructions
When using the soft bar and maul on the output shaft,
be careful not to damage the threads.
When removing the rear bearing cover, the rear
bearing cone drops from the housing bore.
Special Tools
Typical service tools are needed
Vise with brass jaws or wood blocks
Press
Soft bar and Maul
To Disassemble
1.
Use a soft bar and maul to drive the output shaft
forward and through the rear bearing assembly.
2.
From the auxiliary housing rear, remove the rear
bearing retaining capscrews, cover, and gasket.
3.
Clean the gasket mounting surface of gasket
material.
4.
Inspect the rear bearing cover oil seal for
damage, remove if damaged.
5.
From the auxiliary housing rear, remove the
bearing cup and spacer.
6.
From the auxiliary housing front, remove the
remaining bearing cup.
7.
From the output shaft, remove the bearing inner
spacer.
8.
Use the output shaft assemble gear front face as
a base, press the output shaft through the
bearing and gear.
A/05-2
A/05-3
A/08-1
A/09-6
2
8
A/05-1
A/09-3
A/05-4
6
7
1
4
5
