28
Transmission appearance may differ, procedure is the same.
Shift Bar Housing
How to Remove the Autoshift Assembly
Special Instructions
Make sure all labels are in the right place.
Note locations and positions of terminals and
connectors.
Use the removal tool included on the harness to
disconnect the in-line connectors.
The air hoses, shift bar cover assembly, and autoshift
harness connectors must be disconnected.
Special Tools
Typical service mechanic tools needed
To Remove
1.
Disconnect the 2 pin in-line connector from the
input shaft speed pick-up using the removal tool.
Slide the tool along the wire into the insert cavity
until it engages the conact and resistance is felt.
The contact retaining clip will be in the unlocked
position.
2.
Pull the contact wire assembly with tool out of
the connector.
3.
Repeat steps 1 and 2 to disconnect the output
shaft speed pick-up.
4.
On the shift bar housing, loosen the two switch
screws on the range switches and remove the
autoshift harness lead ends.
5.
Remove the four (4) allen head screws and
washers from the autoshift assembly.
6.
Remove the autoshift assembly and harness.
7.
Remove the air supply O-ring and gasket.
S 4
S 2
S 6
S 3
S 5
P 3
P 2
P 1
P 4
S 1
S 7
KEEP
WIRES
OUT
OF
THIS
AREA
TIE WRAP ALL WIRES - EXCEPT S2
S4
S6
S2
S1
S7
P2
P1
P4
P3
S5
S3
6
H/46-9
H/47-2
H/47-5
Line drawing
H/47-1
H/51-2
H/47-6
1
2
3
5
6
7
4
