Transmission appearance may differ, procedure is the same.
4
Shift Bar Housing
How to Disassemble the Shift Bar Housing
Special Instructions
The shift bar housing must be removed from the
transmission.
During disassembly, lay all parts on a clean bench in
order of removal to facilitate assembly.
Shift bars not being removed must be kept in the
neutral position or the interlocking parts lock the bars.
Start with the top shift bar.
Cut the lockwire and remove the lockscrews from each
bar just before their removal.
Use
caution
when removing the range sensor bar, it is
under spring tension.
Special Tools
Typical service mechanic tools needed
Vise with brass jaws or wood blocks
To Disassemble
1.
If the three (3) sets of tension springs and balls
from housing bores have not been removed,
place the shift bar housing on its side to remove
them.
2.
With the housing rear to the right, place the
assembly in a vise.
3.
While removing the top yoke bar to the right,
remove the shift yoke and shift block.
4.
From the second yoke bar, remove the shift yoke
and shift block.
5.
From the third yoke bar, remove the shift yoke.
6.
Place your hand over the range sensor bar
opening on the shift bar housing backside. From
the housing front, remove the range sensor pins.
7.
Carefully remove your hand in order to remove
the range sensor bar and spring.
8.
Inspect the yoke and block parts, replace the
worn parts.
H/13-6
H/13-2
H/14-2
4
3
2
7
H/14-6
6
5
6
H/14-4
