Eaton S090ST, Руководство пользователя

Страница: 40 / 63

39
ROTARY TOW BEHIND REV010322
At this point you must attach the trailer power supply cable to the towing vehicle trailer power supply. This will power
the trailer lights during towing and ensure safe operation of the trailer signaling devices.
1
2
Once the trailer hitch is locked securely in the hitch
mount, you will need to raise the trailer support leg to
travel height. Begin by pulling the retaining wire off of
the pin holding the leg in place (pin and retaining wire
marked as 1 in the drawing). Slide out the pin. Pulling
upward from the top of the leg, raise the leg to travel
height, marked as figure 2. Replace the pin ensuring to
use the retaining wire to lock the pin in place.
ONLY PULL UPWARD ON THE SUPPORT LEG, DO NOT
ATTEMPT TO LIFT FROM THE BOTTOM!
Shifts in the
vehicle or trailer, hitch failure, or improper mounting
may lead to severe injuries to personnel.
After the trailer support leg is locked into place, YOU
MUST install the safety cables as shown. Safety cables
should be installed straight and should not cross.
DO NOT MODIFY TRAILER SAFETY CABLES IN ANY WAY!
Cable attachment on the trailer side should be checked
for frays, damage, and tightness prior to installation.
Gloves should be worn when handling cables as the steel
may become frayed an/or have sharp edges that may
lead to injury if handled without proper safety
equipment.