Eaton S090ST, Руководство пользователя

Страница: 13 / 63

12
ROTARY TOW BEHIND REV010322
Prior to Towing
1. Ensure the enclosure surrounding the unit is correctly closed and secured.
2. Make sure that the tires are in good condition, inflated to the correct pressure, and the lug nuts are tightened to
the correct specification.
3. Verify that all signal lights function correctly, and the connection voltage is 12V.
4. Check the compressor is securely fastened to the trailer.
5. Verify the stand leg is raised and safely locked into position.
6. Make sure that the signal lights and/or reflectors are clean and not damaged.
7. Adjust the draw bar to the height of the towing vehicle and/or towing equipment so that the draw bar is as level as
possible and correctly lock appropriate pins and levers in place.
8. Ensure the hitch ball is locked securely in place and the trailer cannot disconnect from the towing vehicle.
9. Connect signal cables and check the proper function of the lights.
10. Hook the safety chains to the towing equipment.
11. Ensure chains and cables do not interfere with the movement of the compressor or drag along any surface.
12. DO NOT use this equipment to tow or move personnel.
13. DO NOT transport the unit with more than 4 gallons of fuel in it.
14. DO NOT operate the unit while it is in motion and DO NOT operate the unit while the compressor is being towed.
Electrical Safety
1. Follow all NEC and local codes for electrical wiring. Allow only authorized service personnel or certified electricians
to install electrical components.
2. Ensure that incoming service has adequate ampere rating.
3. Do not used mixed wire sizes when wiring the unit.
4. The unit must be properly grounded. DO NOT connect ground to air or cooling lines.
DANGER: Be sure only trained and authorized personnel install and maintain
this compressor in accordance with all applicable federal, local, and state
codes, standards, and regulations. Follow all NEC (National Electric Code)
standards especially those concerning equipment grounding conductors.
DANGER: Improperly grounded electrical components are shock hazards.
Make sure all components are properly grounded to prevent death or serious
injury.