Eaton PowerXL DC1, Руководство по установке

Страница: 98 / 179

3 Installation
3.6 Electrical Installation
94
DC1 Variable Frequency Drive 04/16 MN04020003Z-EN www.eaton.com
3.6.2.10 Control signal terminals IP66
In the case of DC1 variable frequency drives with an IP66 degree of
protection, the plug-in control signal terminals are located under the terminal
cover. In version DC1-…A6SN, the local controls will already be connected.
Figure 59: DC1-…A6SN (connection wired at the factory)
When supplied, the control signal terminals will be connected as follows:
Table 12: Configuration of the control signal terminals
When the device is set to its default settings, the setpoint value can be set
using the potentiometer. Meanwhile, the REV – 0 – FWD selector switch can
be used to set the drive’s operating direction (counterclockwise rotating field
mode – STOP – clockwise rotating field mode).
Pin Color Function
1 RD (red) +24 V to FWD/REV selector switch
2 BU (blue) From selector switch = FWD
3 YE (yellow) From selector switch = REV
5 GN (green) +10 V to potentiometer
6 WH (white) From potentiometer = f-Set
7 BK (black) 0 V to potentiometer
REV FWD
0
ON
OFF
PWR
1 2 3 4 5 6 7 8 9 10 11
U V W L1/N L2/N L3
⏚ ⏚
1 2 3 4 5 6 7 8 9 10 11
1 2 3 4 5 6 7 8 9 10 11
+24 V
DI1 AI1
0 V
DI2 DI3
AO1
0 V
K13 K14
+10 V
BK
WH
GN
YE
BU
RD