Parameter setting
57
11/04 MN01219002Z-EN
You will receive this error message if you try to modify the
address when network communication is active.
You will receive this error message if you attempt to enter an
invalid address.
These fault messages will be displayed for a maximum of 5 s
or until the
ESC
or
OK
buttons are pressed. The DMI will
then return to the previous selection menu.
Startup behaviour
This is used to specify the startup behaviour of the DMI in
communication with the circuit-breaker:
X
In the Com menu use the cursor buttons
Í
or
Ú
to select
Startup.
X
Confirm your selection by pressing
OK
.
During connection establishment, the DMI uses the serial
number of the circuit-breaker to check whether it has
previously communicated with it. If this is the case,
communication will continue further. If the connection has
been made to an “unknown” circuit-breaker, the further
behaviour of the DMI will be determined by the Stop
parameter.
X
Use the cursor buttons < or > to select between Y and N.
• If N is selected, communication between the DMI and the
NZM is continued unhindered.
• Selecting Y will activate Stop mode. The DMI will interrupt
the connection being established to the circuit-breaker. It
will ask whether the new serial number is to be accepted.
There are two options for this:
– Confirm the acceptance of the new serial number by
pressing
OK
. At the same time, this will make the
parameters stored in the DMI for the new connection
Module
Modified
Address
Invalid
Module
Value
Address
Invalid
STARTUP
Stop (Y/N)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
