Getting Started
Eaton Network Card-MS User’s Guide P-164000100—Rev 1
www.eaton.com/powerquality
12
2.
Follow the instructions and enter the static IP parameters.
Wait until
Done
displays, indicating that the IP parameters have been saved.
3.
To exit, type
0
and press
Enter
.
4.
Type
1
and press
Enter
, and then type
2
and press
Enter
to restart.
The card restarts with the new IP settings in approximately one minute.
NOTE
The IPv6 parameters are read only through the serioal line configuration menu. If IPv6 is
enabled, all IPv6 addresses of the card can be read from the HyperTerminal
®
(see the previous
section, “Configuring the Network With a DHCP Server” on page 10).
Testing the Configuration
To verify that the Network Card-MS is operational:
1.
Open a Web browser from a station connected to the same subnet as the card.
2.
Enter the card’s
IP address
in the address bar. The home page displays (see Figure 12).
Figure 12. Home Page
Continue to Chapter 3, “Configuring the Card” on page 13 for additional configuration options.
Содержание Network Card-MS
Страница 1: ...Eaton Network Card MS User s Guide...