Getting Started
Eaton Network Card-MS User’s Guide P-164000100—Rev 1
www.eaton.com/powerquality
11
2.
Type
1
and press
Enter
. The card displays the settings supplied by the server (see Figure 10).
Figure 10. Network Configuration Menu
3.
Record the IP address. The IPv6 parameters are read only.
4.
To exit, type
0
and press
Enter
; then type
0
and press
Enter
again. The card is now operational.
Configuring the Network Without a DHCP Server
To set the network configuration manually:
1.
From the main menu, type
2
and press
Enter
. Type
2
and press
Enter
again to modify the network settings.
The Network Settings menu displays (see Figure 11).
Figure 11. Modifying the Network Settings
NOTE
As long as the card is not connected to the network, it continuously attempts to
make connection. Once the connection has been established, the operational mode
presended in the table becomes effective.
-------------------------------------------------------------
Network configuration
-------------------------------------------------------------
MAC address : xx:xx:xx:FD:xC:xx
Mode :
S
tatic IP
IP address : xxx.xx.xxx.87
Link Local IPv6 address : FExx::xxx:xxFF:FEFD:xxxx/xx
Global IPv6 address :
2001:xxx:xxx:xxxA:xxx:xFF:F
S
FD:xxxx/xx
Global IPv6 address :
1789:xxx:xxx:xxxA:xxx:xxFF:F
S
FD:xxxx/xx
S
ubnet mask : 255.255.xxx.0
Gateway : xxx.xx.xxx.1
-------------------------------------------------------------
-------------------------------------------------------------
Network settings
-------------------------------------------------------------
1 : Read Network settings
2 : Modify Network settings
3 :
S
et Ethernet speed
0 : Exit
-------------------------------------------------------------
For each of the following questions, you can press <Return> to select
the value shown in braces, or you can enter a new value.
S
hould this target obtain IP settings from the network?[N] N
S
tatic IP address [xxx.xx.xxx.xx]? xxx.xx.xxx.87
S
tatic IP address is xxx.xx.xxx.87
S
ubnet Mask IP address [255.255.xxx.0]? 255.255.xxx.0
S
ubnet Mask IP address is 255.255.xxx.0
Gateway address IP address [xxx.xx.xxx.1]? xxx.xx.xxx.1
Gateway address IP address is xxx.xx.xxx.1
Wait while your new configuration is saved...
Reset the card to enable the new configuration.
Содержание Network Card-MS
Страница 1: ...Eaton Network Card MS User s Guide...
