i-on40 & i-onEX Range
3. Setting and Unsetting
Page 33
2.
Complete setting using the method programmed by the Installer (see
“3. Finishing Setting” on page 24).
Unsetting
1.
Enter by the designated entry door.
2.
Press on your remote control.
The system unsets. At this point the system displays the standby screen.
Note: Your administrator may have programmed the control unit so that you
cannot unset the alarm system using a remote control. See page
100. However, if the entry timer has started then you can still use
your remote control to unset the system.
If The System Will Not Set by Remote Control
If one of the detectors is still active when you try to set the system then you
will not hear the exit warning tone. Instead the internal sounder will give a
single beep.
What happens next depends on how the installer has set up your system.
a)
Try pressing A once more on your remote control. If the installer has
programmed the system to do so then it will carry on and set, omitting
the active detector.
b)
If the system will not set on the second press of button A then you will
have to go to the keypad and set the system from there.
Using a Two-Way Key Fob
Note:
1. You must ask your Administrator to provide a suitably
programmed Two-Way Key Fob, see page 12.
2. If your system is certified to BS8243 (ask your Installer) then do
not use a FOB-2W-4B as it will not comply with the entry and exit
requirements. (It could however be used on a compliant system to
unset the system if the building is locked using electronic locks on
the entry doors.)
Setting the System
Press and
hold:
The setting LED flashes red three times.
The system sets. The control unit sends a
message to the fob.
