![background image](http://html1.mh-extra.com/html/eaton/elc-caenet/elc-caenet_manual_524569048.webp)
ELC Distributed I/O Adapters
MN05002003E
For More Information visit:
www.eaton.com
117
The following window will open after the ECISoft button is clicked:
The ELC programming cable (ELC-CBPCELC3) may be used to connect to and configure each
Ethernet module or Ethernet may be used to connect to both modules. For this example,
RS232 was used to initially configure the IP address and Subnet Mask for each Ethernet
module. The Ethernet modules do support DHCP. Note: the default IP address setting for the
ELC-COENETM module is IP address 192.168.1.5. The PC IP address and network mask need
to be set up to reside on the same network as the ELC-COENETM. This will allow you to
immediately connect to each module using ECISoft on Ethernet. If you choose to use RS232 to
configure the Ethernet modules, use the ELC programming cable to connect to each Ethernet
module to set the IP address and Subnet Mask. The computer and both Ethernet modules must
then be connected to an Ethernet switch. Be sure the subnet mask is the same for all devices.
In ECISoft select the Tools drop down menu then choose Communication Setting. For this
example the IP addresses are set up for each device as shown earlier in this document. The
Communication Setting page looks like the following: