![background image](http://html1.mh-extra.com/html/eaton/ec500/ec500_operation-handbook_3906325029.webp)
EC500 Controller Handbook
Copyright © 2019 Eaton Corporation. All Rights Reserved.
Issue A March 2019
Page 29 of 107
Parameter
Description
Where to find:
Duration
Once started, equalization will continue for
“
duration
” hours unless terminated due
to below
reason.
Function disabled during charging.
Battery temperature reaches the abort value.
Home>Settings>Battery
Settings>Charge Profile>Equalize
Mode (Enable)
Day Interval
Equalization will repeat after “
Interval
” days.
Max Equalize Temp
If this function is enabled, Controller will abort the
Equalize mode if battery temperature reaches this
value.
BATTERY TEST
Battery test is a preventative maintenance tool that monitors the discharge capabilities to ensure that the
condition of the battery has not deteriorated over time.
Battery test starts at the scheduled date and time, when the battery is in float mode or battery SOC is 100%.
Rectifiers stop sharing the load current and the load current is supplied by the battery. The battery will start to
discharge. Battery test-set log is stored in event logs.
Battery test will stop if any of the below conditions becomes true:
•
Battery SOC is still greater than 80% but function reaches the duration time i.e. 1hr.
•
Mains Fail-set
•
Function disabled
•
High Battery temperature
•
Battery temperature sensor fail
➢
Enable Battery Test
•
Use the keypad to go to Menu>Maintenance>Battery>Battery Test>Battery1>Battery Test Status.
Enter the appropriate pin then user will be able to see settable parameters.
•
Use Web page to go to Menu>
Maintenance>Battery>Battery Test>Battery1>Battery Test Status.
Configuration
Set the following parameters.
Parameter
Description
Where to find:
Battery Test
Status
Function need to set for enable the battery test.
Display:
Menu>Maintenance>Battery>Battery
Test>Battery1>Battery Test Status
Web:
Menu>Maintenance>Battery>Battery
Test>Battery1>Battery Test Status
Date & Time
The Date and Time that the first battery test cycle will
occur. Subsequent test will occur at every Battery Test
Interval after that.
End of Discharge
Voltage
If the Bus voltage drops below this value during a
battery test, then the test fails.
Duration
The maximum time a Battery Test process will be
active. The Battery test will pass if the Bus Voltage
remains above the Battery Test Termination Voltage
for the duration of the test.
Information
The following information is available about Battery Test: