Installation Leaflet
Page 31 Effective: April 2003
Pow-R-Command 100
IL01412003
For More Information visit www.cutler-hammer.com
STEP 7:
Tap the “OK button as directed to
establish communication with the controller
(Figure 7-6).
STEP 8:
The screen will now change to
display the controller data. If the screen
does not display the “Modify System” data
as shown in Figure 7-7 then simply tap the
“View” menu item in the lower left corner of
the screen and then tap the “System” menu
choice.
STEP 9:
Use the stylus to select the
“Controller Address” field of the display and
then tap the right-arrow at the bottom
center of the screen. (Note. You can
alternately try double-tapping the “Controller
Address” label to open the edit screen.
STEP 11:
In the resulting edit parameter
screen enter the desired address for this
controller. Remember that controller
addresses must be unique. DO NOT choose
an address already assigned to another
controller.
STEP 12:
Tap OK in the upper right corner
of the screen to assign the address.
STEP 13:
Use the stylus to select the
“Controller Name” field and then tap the
right-arrow button in the bottom center of
the screen.
STEP 14:
In the displayed edit window
enter a unique 4-character name for this
controller. It is generally good practice to
make this name some abbreviated version
of the Panel Designation. The name should
start with a letter, and can contain both
letters and numbers.
STEP 15: Tap
OK in the upper right corner
of the screen to assign the name to the
controller.
Figure 7-6: Screen Shot From Hand-Held PC Software For Configuring New
Pow-R-Command 100 Controller
Figure 7-7: Screen Shot From Hand-Held PC Software For Configuring New
Pow-R-Command 100 Controller
