Eaton 9395 Plus 1, Инструкция по установке и эксплуатации

Страница: 17 / 186

INTRODUCTION
Eaton 9395 Plus 1 UPS (225–275 kVA) Installation and Operation Manual
S
164201710 Rev 2
www.eaton.com\powerquality 1-7
1.4 Basic System Configurations
The following basic UPS system configurations are possible:
S
Single UPS with two common battery UPMs and two to four battery cabinets for
both UPMs
S
Single UPS with two separate battery UPMs and two to three battery cabinets
for each UPM
S
Single UPS with two common battery UPMs and a standalone common battery
rack system
S
Single UPS with two separate battery UPMs and two standalone separate battery
rack systems
S
Distributed bypass system with two to five UPSs and a customer-supplied
tie cabinet
The UPS system configuration can be enhanced by adding optional accessories such
as a Remote Emergency Power-off (REPO) control, RMP II, or X-Slot communication
cards.
The base configuration (first two digits of the configuration number) for the UPS is
listed in Table 1‐1. The configuration number can be found on the rating label
mounted on the internal safety shield panel inside the front door.
Table 1‐1. Base Configuration Digits
Configuration Base Digits
275 kVA ISBM, two UPM, Continuous Static Switch (CSS) CB
1.5 Using This Manual
This manual describes how to install and operate the Eaton 9395 Plus 1 UPS
(225–275 kVA) cabinet. Read and understand the procedures described in this manual
to ensure trouble-free installation and operation. In particular, be thoroughly familiar
with the REPO procedure (see paragraph 7.3.25 on page 7-28).
The information in this manual is divided into sections and chapters. The system,
options, and accessories being installed dictate which parts of this manual should be
read. At a minimum, Chapters 1 through 4 and Chapter 7 should be examined.
Read through each procedure before beginning the procedure. Perform only those
procedures that apply to the UPS system being installed or operated.