15
( Figure 10 )
1
. Front working table 2.Front top roller 3. Pressure-adjusting linkage shaft
4. Top guiding roller 5.Film 6. Backing paper roller 7. Backing paper
8. Cold film roller 9. Rear top roller 10. Rear bottom roller 11. Lining paper
12. Double-face film roller 13. Lining paper ( for double-face film)
14. Bottom guiding roller 15. Front bottom roller
C. Function setting:
1) Turn the Cold mounting and Heat-up to Cold mounting.
2) Turn the Speed-regulating knob to what you require.
5.
Cut to separate the film from the backing paper at an appropriate place,
and pull up the backing paper straightly, and tape it plainly on the
paper tube ( or directly on the backing paper roller). Adjust the
pressure-regulating nuts on the roller to gain proper friction.
6.
If the front edge of the picture and text is neat, you can align its two
sides
with the film. Then roll the picture and text into the two rollers by using
the pedal switch. Make sure everything is ok before turning the knob to
‘
Continuous
’
. Leave the pedal switch and carry out continuous lamination.
7.
If the front edge is not neat, lift up the roller and aim the picture and
text
at the middle of the film and align its two sides, then lower the roller and
then roll the picture and text into the two rollers by using the pedal switch.
Make sure everything is OK before turning the knob to
‘
Continuous
’
. Leave the
pedal switch and carry out continuous lamination.
Please note that when rolled into the two rollers, the picture and text must be
very plain. The front edge of the picture and text should be fed into the rollers
all at the same time for lamination, in case drapes appear during the laminating
process.
▲
The picture and text should be wider than the film, in case the film may stick
on to the roller.
2. The instructions and steps of how to use heat-sensitive single-face film
in continuous lamination:
OPP film is the commonly use material for single-face lamination. Its feature
is that it has no backing paper, and there is a thin layer of heat-sensitive glue
on the surface of the film, lamination can only be carried out with a high
temperature. And the laminating quality mainly depends on the temperature on the
roller
’
s surface, the speed, the temperature for melting the glue, the environment
temperature and so on. Pay attention to the control of the above factors during
