17
roller 10）Film 11）Heat-sensitive film 12）Bottom guiding roller
3．Function setting：
A．Press the key for ‘Hot’
；
B．Press the key for ‘Single’roller heat-up；
C．Choose a temperature which is fit for the lamination；
D．Adjust the speed to what you need；
When ‘Ready’ light is on，the heat-up process is over.
4.How to feed in the film:
Tape the picture and text plainly onto the lining paper.
Note:
▲The two edges should be vertical to the roller, in case inclination
may be caused during lamination.
▲
The picture and text should be wider than the film, in case the film may stick on to
the roller.
▲If you want a quick heating-up, you may choose
‘
Double
’
roller heat-up
first. When the temperature reaches around 60℃, turn back to
‘
Single
’
.
5. Insert the picture and text in between the two rollers by using the pedal switch.
After making sure everything is OK, press the key for
‘
Continuous
’
, then leave
the pedal switch and finish the work.
Note:
While the picture and text being inserted, they must be plain and their front
edge should be put in all at once, in case inclination or drape may be caused.
▲
There is a proportion between temperature and speed. Never try to gain high
speed and temperature all at one time, in case the laminating quality may
be affected.
▲
Observe the consequence closely during lamination. If find the heat-sensitive
film is not melted totally, turn the temperature higher ( or lower the speed ).
And if find any distortion of the laminated object, turn the temperature down
( or turn up the speed ).
▲
If there are obvious drapes on the picture and text, stop the machine, pull
the film flat and do the work again.
