12
·
Switch on the power supply and choose any function key or knob as you need.
·
When doing cold mounting work, press Cold.
·
When doing hot laminating work, press Heat-up.
·
When doing single-face or double-face lamination, just choose Single-roller or
Double-roller Heat-up accordingly.
·
Select the films: The material and quality of the film are quite important to
the quality of lamination. It is recommended that you’d better select films of
better quality.
·
Select the films a little narrower than the picture and text ( the picture and
text should have margins on all sides), and if there are no margins forcutting,
lining paper should be applied on the back (or at least on both sides of the
picture and text), and the lining paper should be wider than the film.
·
Put film rolls onto the material roller:
1)Loosen the screws on the positioning sleeve of the material roller.
2)Put the film roll onto the material roller.
3)Fix the removed positioning sleeve on one end of the paper core.
4)Adjust the distances between the two positioning sleeves according to the
practical width of consuming materials so as to make the film in the middle
of the material roll.
5)Fasten the screws for positioning sleeve of material rollers (Note: there
should be
3～
5mm clearance between the positioning and the adjusting
sleeves of material rollers so as to make transverse adjustments easier).
6)Adjust the friction forces by turning the adjusting nuts of the material
rollers ( Note: the friction forces should not be too big ).
( Please refer to the illustrations of Figure 8)
( Figure 8 )
1. Material roller shaft 2. Cold film ( lining paper ) 3. Paper tube
