EASTMAN 3059, Инструкции по модификации

Страница: 78 / 115

3 01MAY97 – 8B7489
PLEASE NOTE The information contained herein is based on the experience and knowledge relating to the
subject matter gained by Eastman Kodak Company prior to publication.
No patent license is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and
makes no warranty, express or implied, with respect to this information. Kodak shall not be
liable for any loss or damage, including consequential or special damages, resulting from any
use of this information, even if loss or damage is caused by Kodak’s negligence or other fault.
This equipment includes parts and assemblies sensitive to damage from electrostatic
discharge. Use caution to prevent damage during all service procedures.
Table 1 Modification Kit 9B8368 includes:
Service Effects: See the table below for the new part descriptions and numbers.
Special Requirements: Some of the existing SPROCKETS may be so corroded that you could cause
damage to the SHAFT of the SQUEEGEE DRIVE ROLLER when you remove
the SPROCKET. To avoid another service call and lost time, have a new
SQUEEGEE DRIVE ROLLER with you. The part numbers are:
270 RA PROCESSOR or MULTILOADER 300 1C0985
180 LP or 180 LPS PROCESSOR 8B7110
NOTE: When you order one of the above ROLLERS, you will receive Kit
No. 9B8087. This Kit includes the new improved SQUEEGEE ROLLER
8B7110 and the parts and instructions to install it.
Serial Numbers: 270 RA PROCESSOR All
MULTILOADER 300 101 - 1499 (Serial No. is for the Processor)
180 LP PROCESSOR 101 - 3399
180 LPS PROCESSOR 10,001 - 13,199
Special Tools: TL-2020 CRIMPING TOOL (or the equivalent)
TL-2275 WIRE STRIPPING TOOL (or the equivalent)
Installation Time: Approximately 1.5 hours
Parts Status: Available from Service Parts Management
Parts Requirements: See the Parts List below
Part No. Description Quantity
9B8352 THERMOSTAT - OVER-TEMPERATURE 1
9B8353 THERMISTOR - DRYER 1
331083 SPLICE - CLOSED-END 5
8B7389 YOKE AND PIN ASSEMBLY 1
8B7109 SPROCKET 4
8B7489 Mod Instructions 1