EASTMAN 3059, Инструкции по модификации

Страница: 64 / 115

Installing the TUBING ASSEMBLY COVER
8B6658 – 29JUN96 5
Section 2: Installing the TUBING ASSEMBLY COVER
[1] See Step 13 on Page 4 to determine if Sections 2 and 3 must be done.
Figure 3
Cutting the WET SECTION COVER
[2] Use the TIN SNIPS or the HACK SAW to cut the WET SECTION COVER as shown in Figure 3 above.
[3] Using the TUBING ASSEMBLY COVER as a template, do the following steps:
(a) Align the TUBING ASSEMBLY COVER with the WET SECTION COVER as shown in Figure 4 below.
(b) Check that the edge of the TUBING ASSEMBLY COVER is under the WET SECTION COVER. See
Figure 4.
(c) Use the CENTER PUNCH to mark the holes.
(d) Use the 3.2 mm (
1
⁄
8
in.) DRILL BIT and the ELECTRIC DRILL TL-1466 to drill the holes.
[4] Install the TUBING ASSEMBLY COVER by inserting the 3 FASTENERS up through the holes in the
TUBING ASSEMBLY COVER and the bottom of the WET SECTION COVER.
Figure 4
Installing the TUBING ASSEMBLY COVER
8.6 cm 3mm
(3 3/8 in. 1/8 in)
+
+
3.2 cm 3mm
(1 1/4 in. 1/8 in)
+
+
H104_0537BA
H104_0537BCA
COVER
WET SECTION
H127_0184BC
H127_0184BCA
FASTENER (3)
COVER
ASSEMBLY
TUBING
COVER
WET SECTION