Eastey VS1620, Руководство пользователя

Страница: 31 / 66

Maintenance 31
2. Apply PTFE tape close up to the seal band over the silicone pads for the entire
length and apply the tape around the outside of the channel flanges to cover the
seal pad completely.
Lower Seal Bar Assembly
1. Route the seal band centered along the top of the silicone pads and through the
groove in the ceramic corner radius guide. Insert each end of the seal band into
each of the spring collets. Keep the band and compensators straight and level
and make sure the band and compensators move freely.
Important: The seal band must be straight and level and must be able to
move freely with minimal friction between the spring
compensators and ceramic corner radius with no sticking or
binding at any point along the band.
The spring compensators secure each end of the seal band and maintain uniform
tension as the seal band heats up and expands or cools down and retracts. If
the seal band is not allowed to expand smoothly and uniformly, it can
develop hot spots. Care must be taken when replacing parts to avoid premature
wear leading to failure, such as, cuts or tears in the PTFE tape, excessive pad
wear, and hot spots in the blade that can lead to premature blade failure.
2. When the seal band is working satisfactorily, reinstall the red compensator cover
over each of the spring compensators, re-using the original hardware.
Silicone
Pad
Ceramic Corner
Radius Guide
Silicon
Pad
Extrusion
Silicone
Pad
PTFE
Tape
Extrusion