©Basic Coatings • All Rights Reserved. • Worldwide Headquarters • 400 Van Camp Road • Bowling Green, OH 43402
800-441-1934 • [email protected] • www.basiccoatings.com
Hydroline Sealer • 08.2018 • Page 1
Technical Data
Hydroline
®
Sealer is a VOC compliant, waterbased penetrating sealer formulated for use for sports floors, maple residential and
commercial wood floors.
Waterbased Wood Floor Sealer
RECOMMENDED USES
•
Commercial
– Meets ADA requirements for use in hotels,
restaurants, shopping centers, dance floors, classrooms, stages,
offices, and retail establishments.
•
Sports
– Gymnasiums, exercise and aerobic floors.
PROPERTIES
Color in Container ..........................................Milky white (dries clear)
Solids Content .................................................................... 26% +/- 2%
VOC ...................................................Does not exceed 250 grams/liter
Flash Point ........................................................... Greater than 200º F
Freeze/Thaw Stability
Stable for at least 5 cycles
(if frozen, thaw completely before using)
Dry Time ............................................................... Minimum 2-3 hours
Clean Up ......................................................................................Water
Coverage ................................................................. 600 sq. ft. / Gallon
Flash Point ........................................................... Greater than 200º F
Stability .................. 1 year shelf life under proper storage conditions
Storage ............................................Do not store above 120° F (49° C)
Packaging.................................... 1 US gallon plastic pail (4 per case)
5 US gallon plastic pails
RECOMMENDED APPLICATORS
• Use Basic Coatings
®
T-bar or Synthetic Lamb’s Wool.
B0656
HYDROLINE
®
SEALER
RECOMMENDED SYSTEMS
Full Sand
- 1-2 coats Hydroline Sealer followed by 2 coats of Basic
Coatings waterbased finishes.
NOTE: Substitute 2 coats of Commercial Catalyzed Sealer in high
traffic commercial locations or Lock n’ Seal on white oak or other
species to minimize tannin pull.
APPLICATION OVER STAINS AND PAINTS
Apply paints and stains and allow to dry per manufacturers direction
or longer depending on environmental conditions. Apply 2 coats of
Hydroline Sealer followed by a Basic Coatings waterbased finish.
A test board is recommended with any stain to insure compatibility
and color acceptance.
ADDING WATER
Up to 12 ounces of water can be added per gallon of finish. Adding
water will increase the flow and level time during situations of high
temperature and low humidity.
SURFACE PREPARATION
1. Before sanding, clean the floor using Basic Coatings’ Squeaky
™
Cleaner following label instructions. Cleaning should be done to
remove contaminants from the floor before sanding.
2. Sand floors using accepted NWFA/MFMA procedures. All old
finish must be removed.
A NIOSH approved dust mask should
be worn during sanding.
3. Finish sanding with a new 120-grit screen. DO NOT USE STEEL
WOOL.
4. Vacuum. Tack with a clean, dry Basic Coatings’ Microfiber Mop
until all dust has been removed.
Continued on page 2
