Hydroline Sealer • 08.2018 • Page 2
©Basic Coatings • All Rights Reserved. • Worldwide Headquarters • 400 Van Camp Road • Bowling Green, OH 43402
800-441-1934 • [email protected] • www.basiccoatings.com
SEALER APPLICATION
Always maintain adequate ventilation during all phases of the coating
and drying process.
1. Measure moisture content of floor in several areas.
2. Shake and rock container several times. Use a stir stick to re-
disperse any settlement.
3. Set aside for approximately 10 minutes to allow bubbles to
break.
4. Rinse refill applicator and remove all excess water. This also
helps to remove loose fibers.
5. Apply Hydroline
®
Sealer using standard waterbased application
procedures.
6. Allow each coat a minimum of 30-45 minutes to level.
7. After sealer levels, place fans in an adjacent area to pull
moisture away from the job site. When each coat has dried a
minimum of 2-3 hours (under good conditions), re-measure
moisture content. If moisture content is not equal to the first
reading, allow more dry time. Repeat for each coat.
8. If necessary, abrade between coats to remove debris, hair,
drips, etc. or if the 24-hour window between coats has elapsed.
Abrade with the pad-and-strip system using 180-240 grit
sanding strips. Between coats, vacuum and tack with a Basic
Coatings
®
Microfiber Mop dampened with Squeaky
™
.
9. If the 24-hour window has elapsed, the TyKote
®
Dust-Free
Refinishing System is an to alternative screening the floor. Refer
to TyKote application procedures for details.
10. Apply second coat in the same manner if desired.
PAINTING GAME LINES
Apply any painted game lines after screening and cleaning the second
coat of sealer. Refer to gymnasium technical literature for acceptable
paints and painting procedures.
DRY TIME
Allow at least 2-3 hours between coats and 1 hour of good ventilation
before closing job site.
PRECAUTIONS
KEEP OUT OF REACH OF CHILDREN. FOR INDUSTRY USE.
Caution: May cause eye irritation. Use with adequate ventilation. Close
container after each use. Avoid contact with eyes, skin and clothing.
Wash thoroughly after handling. Keep closures tight and upright to
prevent leakage. Keep container closed. In case of spillage, absorb
and dispose of in accordance with local applicable regulations.
FIRST AID:
FOR EYES: Flush with plenty of water. If irritation persists,
call a physician. IF SWALLOWED: Do not induce vomiting. Rinse out
mouth with water. Call a physician.
OBLIGATION OF MANUFACTURER
The following is made in lieu of all warranties, expressed or implied:
Seller’s and manufacturer’s only obligation shall be to replace such
quantity of the product proved to be defective. Neither seller nor
manufacturer shall be liable for any injury, loss or damage, direct
or consequential, arising out of the use of or the inability to use the
product. Before using, the user shall determine the suitability of the
product for the intended use and user assumes all risk and liability
whatsoever in connection therewith. The foregoing may not be altered
except by an agreement signed by officers of seller and manufacturer.
HYDROLINE
®
SEALER
