Eastey Combination EC Series, Руководство пользователя

Страница: 50 / 81

50 Maintenance
2. If you are installing a new belt, you are finished splicing.
Step 4
– Check Drive Shaft Sprocket Alignment

Check to ensure 3/16-inch clearance between all sprockets (and/or blanks) and
the Z-bends next to them.

Check alignment of sprocket teeth with a straight-edge. (Only necessary if the
sprockets are not keyed to the drive shaft.)
Step 5
– Check Entire Belt Circuit

Z-bends should not come into contact with any conveyor component (including
end rolls, wear strips, transfer support rails, nose bars, etc.)

Adjust as needed.
Step 6
– Adjust Tension

The wire belt used is a low-tension belt. Use minimal tension
— only enough so
the sprockets properly engage the belt.

Run the conveyor and check to make sure it runs smoothly.
Note: Too much tension will cause premature belt failure.
A
C E
B
D
1 3
5
2
4
A
E
B D
C
1 5 2
4
3