76
›
STEP 2
Fitting the axle supports
Now clamp the adapter to the axle, but do not tighten the screws completely just yet, as you can still
adjust the position of the adapter by the amount that the axle supports are out of place due to the
bolts being too far apart. Thus the bolts should initially be partly tightened and then the axle supports
fitted at a height of about 12.5 cm (5”) from the ground. After this, the bolts are fully tightened. Finally,
check that the axle supports hang vertically and are inclined neither inwards nor outwards, nor to front
or rear.
!! Warning:
Fixing the supports is probably the most important step of all in fitting the E&P
levelling system and therefore suitable expertise in this field is indispensable. The forces which act
on the system and the caravan must in no circumstances be underestimated. Do not drill any holes
in the chassis, and contact the dealer in all other cases of uncertainty, as the fitter himself is always
responsible for the installation of the system.
Содержание LEVEL SYSTEM
Страница 1: ... English Electronic Levelling System Assembly Manual ...
Страница 17: ...85 19 Schema der Hydraulikleitungen Hydraulic pipework ...
Страница 21: ...89 Notes ...
Страница 22: ...90 Notes ...