47
MAINTE NANCE
Your
must be unplugged when you are undertaking its maintenance. If you intervene after using
, you must wait the complete
stop of the applicator's fan before unplugging the base. This enables, the optical parts to cool down properly.
NOTE:
Unlike the fans located inside the applicator, the ones located inside the base only stop when the device is unplugged.
y
BASE
PLASTIC PARTS
Do not clean the inside of the slot dedicated to the activation card.
Clean all of the plastic parts with a clean cloth, which has been
dampened with water (without any additives).
TOUCHSCREEN
Clean the screen with a clean cloth that has been dampened with
clean
(never spray
clean
directly on the touch screen).
POWER CORD
Check its perfect condition (must not be pinched or crushed, no
bare wires). Clean with a cloth dampened with water (without any
additives).
y
APPLICATOR
MOBILE HEAD
Cleaning the optical parts (internal and external) of the mobile
head with the spray
clean
before and after each use maintains
your
’s effectiveness.
Never spray
clean
directly on the
internal parts of the applicator.
BODY OF THE APPLICATOR
Clean all of the plastic parts of the applicator with a clean cloth,
which has been dampened with water (without any additives).
y
BASE CABLE TO APPLICATOR
This cable must always stay clean without any visible impairment.
You must never bend it strongly or get it stuck. In case of doubt
cable’s condition, you must stop using your
immediately.
y
THE AIR VENTS OF THE BASE AND OF
THE APPLICATOR
The applicator and the base are ventilated. The grids are found
on both the applicator and the base, on its lower and upper back
part. All of these grids must be clean and there are no elements
likely to clog them.
Be careful not to drop liquid into the ventilation grid located on
the lateral casings.
y
STORAGE
• Place your
in a room where the room temperature does
not exceed 25°C, away from excessive moisture and in a place
where it cannot be subjected to vibration.
•
If the device suffers from an impact, it is necessary to check the
optical parts in their entirety.
•
Any visible damage to the optical parts: filter (flat red part made
of glass), optical guide, tube, etc. must lead to an immediate
cessation of use of the device.
REMINDER:
Storage temperature: -5° C to + 65°C.
Storage temperature for immediate use: +5 ° C to +25 °C.
Use and store in a place where the relative humidity is under 93 %.
46
