NOTE:
With each flash, the zone treated corresponds to the area covered by the end of the optical guide, or 3.75 x 2 = 7.50 cm
2
.
NOTE:
• Ensure that the
Gel
is applied in a generous layer.
•
Gel
must never overflow into the interior of the mobile head of the
device.
•
Gel
must never be applied below the
stop
plate.
NOTE:
If you are planning to flash a large area, do not apply the
gel
over the entire area at the beginning. It will eventually dry out
and lose its effectiveness in terms of optical transmission. Therefore apply the
gel
as you progress onto the area concerned. Once
the
gel
has been used on the skin and has been flashed, it should under no circumstance, be collected and reused on another area:
flashing the gel is likely to cause a change in its optical characteristics.
27
y
STEP 4
DELIMIT THE AREA TO BE FLASHED
To ensure an optimum hair removal session,
pen
are provided. Thanks
to these accessories, it is possible to mark out the areas that need to be
flashed directly onto the skin.
•
Delimit the area to be flashed with the help of the
pen
, by tracing
parallel lines on the large areas.
•
If necessary, use the guide plate
stop
to cover a rather large area that
should not be flashed (tattoos...).
•
Cover potential moles with the
patches
.
•
After applying a thick layer of
gel
over the entire area to be flashed,
move the applicator along the delimited area (refer to the next page to
know how to issue a flash).
•
The applicator’s positioning leaves a print on the skin, which enables
you to see the area that has already been treated. Thus, from one flash
to another, it is very easy to distinguish between an area that has already
been and another area that has not yet been. An overlap of about 1 mm
is possible.
•
If necessary, use
stop
to cover a rather large area that must be flashed
(tattoos…).
REMINDER:
Make sure that you are applying a thick layer of
gel
. The
gel
must never
overflow inside the mobile head of the device.
When selecting the settings for flashing, it is imperative to respect the
instructions of the user manual provided with the device.
If in doubt about the selection of the setting, please contact our sales department
either by telephone or via your client account on
prostore.esw-beauty.com
.
•
Specific treatment programme for highly pigmented skins.
All treatments carried out on highly pigmented skin requires the exclusive use of the “special highly pigmented skin”.
To easily differentiate the basic filter from the
“special highly pigmented skin”
filter, place them side-by-side on a white
material (paper for example). The darker filter is the one dedicated to highly pigmented skins, which corresponds to the
selection of skin type 5 on the touchscreen of the
.
2895
After the flashing session and once the device has stopped running and has been unplugged (see instruction on turning off the device, as defined at
the end of the chapter entitled: “Removing hair with your device”, step “End of the session” of the user manual), it is possible to remove the “special
highly pigmented skin” filter and to place the original mobile head back.
Highly pigmented skins are represented by the icon no.5 when you “select the type of
skin” on the touch screen of your device.
The “special highly pigmented skin”
special filter
must imperatively be put in place
before connecting the device.
Once the new filter has been installed, the device can be started.
When skin type no.5 is selected, the following warning message appears on the screen;
you need to validate it by pressing on OK.
The flashing session can begin once all the settings have been validated.
REMINDER:
You must only use the pencil of work
pen
, the
gel
, the self-adhesive
patches
, the guide plate
stop
and the safety glasses
mask
provided with your
. The use of any other products may cause skin burns and will void the warranty of your device.
Careful
26
REMOVING HAIR WITH
