E-Mu EMAX II, Руководство по эксплуатации, Страница: 142 / 257

Emax II operation manual
131
Use the data slider or numeric keypad to set the arpeggiator velocity value. The lowest
possible value (obtained by entering
000 ) gives the following display:
Velocity: Played
Use Data Slider
Each note will arpeggiate at a volume level determined by the velocity with which the
note was played. Use the data slider to select the range of MIDI velocity values (1- 127),
with larger numbers giving louder levels if the dynamics are mapped to level; when
mapped to other parameters, they are affected appropriately.
To jump back to the module identifier press ENTER , otherwise press the right arrow
cursor key to continue the setup.
14. But wait, there’s still more! Key Repeats sets the number of times that each note plays
before moving on to the next note in the arpeggio. The display says:
Key Repeats: 1
Use Data Slider
Use the ON and OFF buttons or the DATA SLIDER to select the desired number of
repeats on each note (1-8).
15. The next arpeggiator option is Cruz Control, which fits the number of notes you’re
holding into the specified note value (if you can’t picture this effect, then give it a try and
you’ll hear what it does).
The display says:
Cruz Control: on
Select on/off
Use the ON and OFF buttons to select whether Cruz Control is on or off
Note: Cruz Control cannot be used when either Key Repeats or Glissando are on.
Turning on Cruz Control will simply turn off Key Repeats and Glissando.
Arpeggiator
PRESET DEFINITION