E-Mu EMAX II, Руководство по эксплуатации, Страница: 132 / 257

Emax II operation manual
121
PRESET DEFINITION 4 STEREO VOICE
The Emax II plays back stereo samples, with no loss of polyphony. Stereo is implemented
using the primary and secondary voices and selecting Stereo Voice mode.
Stereo Voice mode uses all primary voice parameters for both primary and secondary
layers. With Stereo Voice off, the primary and secondary voice parameters are totally
independent and no sharing of functions occurs.
In order for a key to become stereo, it must meet all of the following criteria:
■
The primary and secondary voices must be assigned to the same keyboard range.
■
Both primary and secondary voices must have the same original key.
■
Both primary and secondary voices must have the same sample rate.
The above rules must not be violated after a stereo voice has been created or unpredict-
able (and undesirable) side effects may result (wrong pitches, etc.).
PRESET DEFINITION
Stereo Voice
■
Stereo Voice mode
may be used to "stack"
voices without loss of
polyphony, since the
primary and secon-
dary voices need not
be the same instru-
ment.
1. Activate PRESET DEFINITION 4 . The display shows:
Lo:XX Stereo:Off
Select Lo Voice
...where XX defaults to the lowest note of the lowest voice.
Press the lowest key of the low voice that you want to put into or out of stereo vioce mode,
or to quickly select the low voice, use the data slider. While selecting the low voice, the
display will show the voice number, its original pitch and whether the voice has stereo
on or off. After selecting the low voice, press
ENTER .
Primary Voices
Secondary Voices
4 2 3 1
4 2 3 1 5
In this diagram, voices 1, 2 and 3 are eligible to become stereo, if the primary and
secondary voices have the same original keys and the same sample rates.