E-flite Sobré 3D Profile Assembly Manual
Installing the Optional
Side Force Generators
Required Parts
Side force generator (upper) (2)
Side force generator (lower) (2)
Carbon rod, 4.3-inch (110mm) (4)
Required Tools and Adhesives
Foam-compatible CA
Square
Note
: The side force generator (SFG) installation is
optional. If you plan on saving weight, or flying from
very rough surfaces, it is suggested to skip this section.
1. Locate the upper side force generator. Position
the SFG on the wing, aligning it with the two holes
that have been pre-drilled in the wing. Use a square
to position the SFG perpendicular to the wing. Use
Foam-compatible CA to glue the SFG to the wing.
2. Locate a 4.3-inch (110mm) carbon rod. Position
the rod in the predrilled holes in the SFG and wing.
Use foam-compatible CA to glue the carbon rod to the
SFG ONLY at this time.