E-FLITE Pulse XT 25e ARF, Инструкция по сборке

Страница: 22 / 36

22
Canopy and Cooling Exit Scoop
Required Parts
Fuselage
Canopy
Cooling Exit Scoop
Required Tools and Adhesives
Low-tack tape
Canopy Glue
Ο 1. Trial fit the canopy on the fuselage. Once satisfied with its location, apply
glue to the inside of the canopy at the areas of the painted frame, and install
on the fuselage. Tape can be used to hold it in place while the glue dries.
Allow the glue to dry completely before removing the tape.
Ο 2. Follow the same procedure to attach the cooling exit scoop on the lower
fuselage behind the wing in the location shown. Note that the opening faces
towards the rear of the model.
N Noottee:: If you opt to fly from land please proceed to the Flight Preparation
section on page 27. If you are installing floats, please proceed to the next
page.