E-FLITE Pulse XT 25e ARF, Инструкция по сборке

Страница: 12 / 36

12
Ο 2. Using a 3/32” balldriver, install the motor on the firewall with four 4-40
x 1/2" socket head bolts. The motor wires should exit towards the bottom of
the fuselage. You may use threadlock to prevent these screws from vibrating
loose in flight.
Ο 3. Remove the battery hatch by sliding it forward to disengage the magnets,
and lifting at the rear. It can then be pulled rearwards and off the model.
Ο 4. Install the battery with two hook and loop straps. Slots are provided on
the floor of the battery compartment for the straps to pass through. The natural
curl of the straps will allow them to be fed down one slot, under the battery
compartment floor, then up through the opposite slot.
Ο 5. Install the ESC on the right-hand side of the battery compartment with
hook and loop tape. The battery leads, switch leads and throttle leads will be
towards the rear of the model. Connect the ESC to the motor.